Posted: 03/August/2007 at 1:19am | IP Logged

You can program a maximum of 4 P12 key fobs as follows:

Obtain all remote controls

Switch ignition ON and OFF 6 times within 10 seconds

After 2 seconds indicators will flash twice. Programming mode will be activated. Proceed as follows:

Press & hold unlock button

Press lock button 3 times

Release unlock button

Indicators will flash once to confirm correct programming

Repeat above procedure to program any remaining remote controls

After fourth key is programmed, indicators flash 3 times to confirm correct programming

Switch ignition ON

Indicators flash twice if 1-3 keys have been programmed

Indicators DO NOT flash if 4 keys have been programmed

Programming mode de-activated

Check operation of all programmed remote controls

If any controls do not work then repeat above procedure. I had to do it twice on one of my controls but it usually does work eventually. Good luck!!